Why do you choose Polyurethane Suspensions?

Suspension buses get a lot to endure and are among the most wear parts of a car.

They undergo extreme stresses under highly varying conditions and have to do so without any lubricant.

The material from which the standard rubbers are made is also subject to an aging process, causing hairline cracks and the material becoming softer. This results in all kinds of unwanted play in the suspension.

It goes without saying that this will not improve cornering behavior and stability and can also cause unnecessary tire wear. A modern material such as polyurethane gives Powerflex suspension sleeves an 25 up to 35 percent greater stiffness without sacrificing the shock-absorbing properties.

A car a few years old drives like new again when the worn out bushings are replaced by polyurethane ones. You avoid uneven tire wear, vibrating brake discs and very poor road holding. New cars also benefit from the Powerflex buses: due to their superior design they give a more effective control of the chassis components than with normal rubber parts.

With the technical advantages of this material it is possible to reduce the most common problem, an increased sound reproduction as a result of (too) hard buses.

The products from the Powerflex Road Series are suitable for normal and sporty street use.

The products ensure that you can handle your car better, prevent uneven tire wear and unstable braking.

These are the most common problems caused by a gentle one,outdated of defective rubber composition of your suspension.

Chip Performance can replace your old worn rubbers for the better powerflex articles.

The advantages of Powerflex:
- Extended life of the tires
- Improved performance
- Increase of the safety
- Greater cost-effectiveness

The Powerflex Black Series products are specially made for Race, Rally and Drift cars.

The Powerflex Black Series products are specially manufactured for the harsh conditions that a car has to deal with during intensive use.

Chip Performance always uses the Powerflex black series products when converting a chassis from an original car to circuit car.
these are stiffer, which greatly improves the handling of the car.